4 manufacturer photos · 1 / 4
Ortur · Diode
Ortur Laser Master 2 Pro
Classic Ortur LM2 Pro — legacy open-frame (used market)
Last updated How we evaluate
Released March 2021
What this machine is for
Budget used-market Ortur for basic engraving
Reference benchmark same job size on every machine so you can compare times fairly.
Laser spot size
~0.08 mm spot
Smaller spot = finer detail (frame motion is usually the same across tiers)
Motion precision: 0.01 mm
Sample engrave job
~12–18 min
Filled photo or logo on birch plywood
10 × 10 cm (4 × 4 in)
Sample cut job
~6–10 min
Simple square cut-out from 3 mm basswood
10 × 10 cm (4 × 4 in)
Times are estimates for the reference job above; your design complexity and settings will change them.
TL;DR
Ortur Laser Master 2 Pro is a discontinued Ortur classic still found used. Fine for learning if cheap; new buyers should choose LM3, H10, or H20 instead.
What this machine is for
Legacy Ortur open-frame for hobby engraving on a budget.
Best for
Materials
Engraves
- · Wood
- · Leather
- · Paper
Cuts
- · 3 mm basswood
Cannot do
- · New manufacturer support
- · Modern speed vs H20
Pros
- ✓Very cheap used
- ✓Huge legacy tutorial base
- ✓Large bed
Cons
- ✗Discontinued
- ✗Outdated vs LM3/H20
- ✗Open frame
Beginner notes
Only buy used at a steep discount vs a new LM3 10W.
Pro tips
Flash firmware carefully — many LM2 guides still online.
Pro / technical specs
Raw numbers for experienced users comparing machines.
- Laser spot size
- ~0.08 mm spot
- Max speed (spec)
- 15,000 mm/s traverse
- Avg engrave speed
- 60–150 mm/s fill
- Avg cut speed
- 4–10 mm/s on 3 mm wood
- Motion precision
- 0.01 mm